DOT & Snell rated SA2005

4MM shield w/ Aluminum Retention Fastening system.
Visor/Shield Lock System.
Tear off Posts.
Removable Washable "Snap-Lock" Interior,
Cheek pads and upper liner are easily removed to allow for cleaning.
Chin/Forehead Ventilation System,
Chin bar and rear exhaust vents, vent air for increased head and humidity dissipation.
Padded chin-strap design. Clearance price limited to quantity in stock.

TRP HELMET SIZING CONVERSION CHART
MEASUREMENT	SIZE	METRIC
20-7/8	6-5/8 (X-SMALL)	53
21-1/4	6-3/4 (X-SMALL)	54
21-5/8	6-7/8 (SMALL)	55
22	7 (SMALL)	56
22-3/8	7-1/8 (MEDIUM)	57
22-3/4	7-1/4 (MEDIUM	58
23-1/8	7-3/8 (LARGE)	59
23-1/2	7-1/2 (LARGE)	60
23-7/8	7-5/8 (X-LARGE)	61
24-1/4	7-3/4 (X-LARGE)	62

Measurement

Proper helmet fit is a vital component to the performance of a helmet during an impact. In order for the

helmet to perform properly during an impact, it must stay securely on the head.
Measuring the head is a starting point for the entire sizing procedure. Due to varying shapes, heads that are

apparently the same size when measured by a tape may not necessarily fit the same size helmet.
A small metal tape measure, or a cloth tape may be used to make your initial measurement. Alternatively, a

string can be used which can then be laid against a measuring tape. The circumference of the head should

be measured at a point approximately one inch above the eyebrows in front, and at a point in the back of

the head that results in the largest possible measurement. Take several measurements, to make sure you

have the largest one. Consult your local dealer for sizing help!